[SOLVED] Пропала сеть после обновления. [РЕШЕНО]

После обновления системы по emerge -uDav world полностью перестал видеть другие компьютеры в стеи.
Причём сеть работает на всех 3х сетевых карточках в LiveCD как дженты так и других систем.

Симптомы:
# ping 192.168.0.1
PING 192.168.0.1 (192.168.0.1) 56(84) bytes of data.
From 192.168.0.25 icmp_seq=2 Destination Host Unreachable
From 192.168.0.25 icmp_seq=3 Destination Host Unreachable
From 192.168.0.25 icmp_seq=4 Destination Host Unreachable
^C
--- 192.168.0.1 ping statistics ---
4 packets transmitted, 0 received, +3 errors, 100% packet loss, time 2999ms
, pipe 3

Конфиги и выводы комманд:

# uname -a

Linux lsd 2.6.27-gentoo-r8 #1 SMP Thu Feb 26 13:39:06 MSK 2009 i686 Intel(R) Celeron(R) CPU 2.66GHz GenuineIntel GNU/Linux

# ifconfig

eth0      Link encap:Ethernet  HWaddr 00:c0:df:f1:16:4e  
          inet addr:192.168.0.25  Bcast:192.168.0.255  Mask:255.255.255.0
          inet6 addr: fe80::2c0:dfff:fef1:164e/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:14 dropped:0 overruns:0 carrier:28
          collisions:238 txqueuelen:1000 
          RX bytes:0 (0.0 B)  TX bytes:948 (948.0 B)
          Interrupt:19 Base address:0xee00 

eth1      Link encap:Ethernet  HWaddr 00:e0:4c:74:e9:c3  
          inet addr:192.168.1.25  Bcast:192.168.1.255  Mask:255.255.255.0
          UP BROADCAST MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:0 (0.0 B)  TX bytes:0 (0.0 B)
          Interrupt:21 Base address:0xe000 

eth2      Link encap:Ethernet  HWaddr 00:15:58:04:41:7b  
          inet addr:192.168.2.25  Bcast:192.168.2.255  Mask:255.255.255.0
          inet6 addr: fe80::215:58ff:fe04:417b/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:3 errors:0 dropped:0 overruns:0 frame:0
          TX packets:8 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:180 (180.0 B)  TX bytes:588 (588.0 B)
          Interrupt:22 

lo        Link encap:Local Loopback  
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:6 errors:0 dropped:0 overruns:0 frame:0
          TX packets:6 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0 
          RX bytes:672 (672.0 B)  TX bytes:672 (672.0 B)

# route -n

Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
192.168.2.0     0.0.0.0         255.255.255.0   U     0      0        0 eth2
192.168.1.0     0.0.0.0         255.255.255.0   U     0      0        0 eth1
192.168.0.0     0.0.0.0         255.255.255.0   U     0      0        0 eth0
127.0.0.0       0.0.0.0         255.0.0.0       U     0      0        0 lo
0.0.0.0         192.168.0.1     0.0.0.0         UG    0      0        0 eth0

# cat /etc/conf.d/net

# This blank configuration will automatically use DHCP for any net.*
# scripts in /etc/init.d.  To create a more complete configuration,
# please review /etc/conf.d/net.example and save your configuration
# in /etc/conf.d/net (this file :]!).
config_eth0=( "192.168.0.25 netmask 255.255.255.0 brd 192.168.0.255" )
routes_eth0=( "default gw 192.168.0.1" )
#mac_eth0=("00:c0:df:f1:44:16:4e")
config_eth1=( "192.168.1.25 netmask 255.255.255.0 brd 192.168.1.255" )
#routes_eth1=( "default gw 192.168.0.1" )
config_eth2=( "192.168.2.25 netmask 255.255.255.0 brd 192.168.2.255" )
#routes_eth2=( "default gw 192.168.2.1" )

#cat /etc/resolv.conf

nameserver 213.177.96.1
nameserver 213.177.97.1

# dmesg | grep eth

[    0.688724] eth0: RealTek RTL-8029 found at 0xee00, IRQ 19, 00:c0:df:f1:16:4e.
[    0.691428] eth1: RealTek RTL8139 at 0xd002e000, 00:e0:4c:74:e9:c3, IRQ 21
[    0.691511] eth1:  Identified 8139 chip type 'RTL-8100B/8139D'
[    0.692290] eth2: RTL8110s at 0xd0030000, 00:15:58:04:41:7b, XID 04000000 IRQ 22
[    0.697743] Driver 'sd' needs updating - please use bus_type methods
[    0.697889] Driver 'sr' needs updating - please use bus_type methods
[   22.991890] eth1: link down
[   22.992274] ADDRCONF(NETDEV_UP): eth1: link is not ready
[   26.780281] r8169: eth2: link up
[   29.866008] eth0: no IPv6 routers present
[   37.361010] eth2: no IPv6 routers present

# dmesg | grep net

[    0.039993] net_namespace: 816 bytes
[    0.140187] audit: initializing netlink socket (disabled)
[    0.160332] SELinux:  Registering netfilter hooks
[    0.690476] 8139too Fast Ethernet driver 0.9.28
[    0.691636] r8169 Gigabit Ethernet driver 2.3LK-NAPI loaded
[    0.695457] console [netcon0] enabled
[    0.695532] netconsole: network logging started
[    1.911104] Driver for 1-wire Dallas network protocol.
[    1.949747] ctnetlink v0.93: registering with nfnetlink.
[    1.952948] Initializing XFRM netlink socket
[    1.959447] NET4: DECnet for Linux: V.2.5.68s (C) 1995-2003 Linux DECnet Project Team
[    1.960163] DECnet: Routing cache hash table of 1024 buckets, 8Kbytes

Расчитываю на вашу помощь.