Проблемы с wifi.
funkypotatoe 3 декабря, 2008 - 01:52
Вечер добрый. Помогите пожалуйста, устал сражаться. Прочитал кучу постов, форумов, затёр до дыр гугл, не могу разобратся в чём дело :( После установки Gentoo был тока wired. Установил iwl4965, сделал линк net.wlan0 -> net.lo, во время загрузки пишет про ошибку конфигурации wlan0, сразу же перестаёт работать eth0 (wired)
mypc ~ # dmesg | tail
iwl4965: WARNING: Requesting MAC access during RFKILL wakes up NIC
iwl4965: WARNING: Requesting MAC access during RFKILL wakes up NIC
iwl4965: WARNING: Requesting MAC access during RFKILL wakes up NIC
iwl4965: WARNING: Requesting MAC access during RFKILL wakes up NIC
iwl4965: WARNING: Requesting MAC access during RFKILL wakes up NIC
iwl4965: WARNING: Requesting MAC access during RFKILL wakes up NIC
iwl4965: WARNING: Requesting MAC access during RFKILL wakes up NIC
iwl4965: WARNING: Requesting MAC access during RFKILL wakes up NIC
ACPI: PCI interrupt for device 0000:02:00.0 disabled
Clocksource tsc unstable (delta = 2155538477 ns)
mypc ~ # ifconfig -a
eth0 Link encap:Ethernet HWaddr 00:1b:24:da:0c:aa
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:213 errors:0 dropped:0 overruns:0 frame:0
TX packets:2 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:35729 (34.8 KiB) TX bytes:120 (120.0 B)
Interrupt:17 Base address:0xa000
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:178 errors:0 dropped:0 overruns:0 frame:0
TX packets:178 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:12876 (12.5 KiB) TX bytes:12876 (12.5 KiB)
wlan0 Link encap:Ethernet HWaddr 00:1d:e0:05:0d:9b
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
wmaster0 Link encap:UNSPEC HWaddr 00-1D-E0-05-0D-9B-00-00-00-00-00-00-00-00-00-00
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
mypc ~ # iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
wmaster0 no wireless extensions.
wlan0 IEEE 802.11 ESSID:""
Mode:Managed Frequency:2.412 GHz Access Point: Not-Associated
Tx-Power=off
Retry min limit:7 RTS thr:off Fragment thr=2352 B
Encryption key:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
/etc/conf.d/net
modules=( "ifconfig" ) modules=( "iwconfig" ) modules=( "!wpa_supplicant" ) essid_wlan0="BTHomeHub-658A" mode_wlan0="managed" channel_wlan0="7" key_essid="***" #key_BTHomeHub-658A="*** enc open" preferred_aps=( "BTHomeHub-658A" ) config_eth0=( "dhcpcd" ) config_wlan0=( "dhcpcd" )
lspci:
02:00.0 Network controller: Intel Corporation PRO/Wireless 4965 AG or AGN [Kedron] Network Connection (rev 61) 06:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8101E/RTL8102E PCI Express Fast Ethernet controller (rev 01) 07:09.0 FireWire (IEEE 1394): Ricoh Co Ltd R5C832 IEEE 1394 Controller (rev 05)
Подскажите хоть что-нибудь.
»
- Для комментирования войдите или зарегистрируйтесь
Ошибка
Ошибка синтаксиса
использование DHCP config_eth0=( "dhcp" )
modules=( "wpa_supplicant" )
буду честен, я не знаю, почему у меня все работает
Спасибо большое, шас попробую
Спасибо большое, шас попробую с dhcp, но мне надо чтобы wpa_supplicant не использовался.
Всё равно не работает
Всё равно не работает :(
dmesg:
iwl4965: Intel(R) Wireless WiFi Link 4965AGN driver for Linux, 1.2.26kds iwl4965: Copyright(c) 2003-2008 Intel Corporation ACPI: PCI Interrupt 0000:02:00.0[A] -> GSI 16 (level, low) -> IRQ 16 PCI: Setting latency timer of device 0000:02:00.0 to 64 iwl4965: Detected Intel Wireless WiFi Link 4965AGN iwl4965: Tunable channels: 13 802.11bg, 19 802.11a channels phy0: Selected rate control algorithm 'iwl-4965-rs' ACPI: PCI interrupt for device 0000:02:00.0 disabled ACPI: PCI Interrupt 0000:00:1b.0[A] -> GSI 22 (level, low) -> IRQ 22 PCI: Setting latency timer of device 0000:00:1b.0 to 64 nvidia: module license 'NVIDIA' taints kernel. ACPI: PCI Interrupt 0000:01:00.0[A] -> GSI 16 (level, low) -> IRQ 16 PCI: Setting latency timer of device 0000:01:00.0 to 64 NVRM: loading NVIDIA UNIX x86 Kernel Module 173.14.09 Wed Jun 4 23:43:17 PDT 2008 fuse init (API version 7.9) Adding 4008208k swap on /dev/sda3. Priority:-1 extents:1 across:4008208k r8169: eth0: link up r8169: eth0: link up ACPI: PCI Interrupt 0000:02:00.0[A] -> GSI 16 (level, low) -> IRQ 16 PM: Writing back config space on device 0000:02:00.0 at offset 1 (was 40100102, writing 40100106) firmware: requesting iwlwifi-4965-1.ucode Registered led device: iwl-phy0:radio Registered led device: iwl-phy0:assoc Registered led device: iwl-phy0:RX Registered led device: iwl-phy0:TX iwl4965: Error sending REPLY_TX_PWR_TABLE_CMD: enqueue_hcmd failed: -5 iwl4965: Error sending SENSITIVITY_CMD: enqueue_hcmd failed: -5 iwl4965: SENSITIVITY_CMD failed iwl4965: Error sending REPLY_RXON: enqueue_hcmd failed: -5 iwl4965: Error setting new configuration (-5). iwl4965: WARNING: Requesting MAC access during RFKILL wakes up NIC ... iwl4965: WARNING: Requesting MAC access during RFKILL wakes up NIC ACPI: PCI interrupt for device 0000:02:00.0 disabled Clocksource tsc unstable (delta = 2155429849 ns)что это значит?
Firmware есть?
Firmware есть? (net-wireless/iwl4965-ucode)
+ Возможно в ядре не включен RFKILL
There is a feature in Micro$oft windows. Just put a string "BUGS=OFF" to your system.ini file. See? That's not a bug, it's a feature.
http://en.gentoo-wiki.com/wik
http://en.gentoo-wiki.com/wiki/Iwlwifi