Главная » Форум » Gentoo Linux » Ядро Linux и поддержка оборудования

при старте не запускается сеть на чипе bcm43xx

Гость 25 Августа, 2007 - 13:40

Добрый день!

На ноутбуке Amilo PRO 2030 установлен Gentoo 2007.0. WiFi на этой машине сделан на чипе bcm4318, драйвер установлен как написано http://forums.gentoo.org/viewtopic-t-409194-highlight-bcm4318.html. Проблема заключается в том, что во время загрузки сеть не поднимается, но вручную после логина сеть нормально поднимается командой /etc/init.d/net.eth0 start Подскажите, пожалуйста, как убедить систему поднимать сеть при старте?

‹ вкл/выкл тачпада по хоткею! Картридер на ноутбуке ›
»

Quote:# rc-update add

Автор bes.internal, дата создания 25 Августа, 2007 - 14:25.
Цитата:
# rc-update add net.eth0 boot

Но в частности не уверен boot или default

»

default, там еще

Автор Graf, дата создания 25 Августа, 2007 - 15:03.

default, там еще firmware подгрузится должно...

»

увы :(, добавил в

Автор Rimas79 (не зарегистрирован), дата создания 27 Августа, 2007 - 20:55.

увы :(, добавил в default - не помогло
вот переписал собщения с экрана:

* Starting eth0
* Configuring wireless network for eth0
* Failed to configure wireless network for eth0

вот сообщения из messages после сразу загрузки:

Aug 27 19:07:03 localhost bcm43xx: PHY connected
Aug 27 19:07:03 localhost bcm43xx: Microcode rev 0x127, pl 0xe (2005-04-18 02:36:27)
Aug 27 19:07:03 localhost bcm43xx: Radio turned on
Aug 27 19:07:03 localhost bcm43xx: ASSERTION FAILED (radio_attenuation < 10) at: drivers/net/wireless/bcm43xx/bcm43xx_phy.c:1496:bcm43xx_find_lopa
Aug 27 19:07:03 localhost bcm43xx: WARNING: Writing invalid LOpair (low: -48, high: 78, index: 120)
Aug 27 19:07:03 localhost [] [] [] [] [] [] [] []
Aug 27 19:07:03 localhost bcm43xx: ASSERTION FAILED (radio_attenuation < 10) at: drivers/net/wireless/bcm43xx/bcm43xx_phy.c:1496:bcm43xx_find_lopa
Aug 27 19:07:03 localhost bcm43xx: WARNING: Writing invalid LOpair (low: -48, high: 78, index: 120)
Aug 27 19:07:03 localhost [] [] [] [] [] [] [] []
Aug 27 19:07:03 localhost bcm43xx: ASSERTION FAILED (radio_attenuation < 10) at: drivers/net/wireless/bcm43xx/bcm43xx_phy.c:1496:bcm43xx_find_lopa
Aug 27 19:07:03 localhost bcm43xx: WARNING: Writing invalid LOpair (low: -48, high: 78, index: 120)
Aug 27 19:07:03 localhost [] [] [] [] [] [] [] []
Aug 27 19:07:03 localhost bcm43xx: Chip initialized
Aug 27 19:07:03 localhost bcm43xx: 32-bit DMA initialized
Aug 27 19:07:03 localhost bcm43xx: Keys cleared
Aug 27 19:07:03 localhost bcm43xx: Selected 802.11 core (phytype 2)
Aug 27 19:07:03 localhost bcm43xx: ASSERTION FAILED (radio_attenuation < 10) at: drivers/net/wireless/bcm43xx/bcm43xx_phy.c:1496:bcm43xx_find_lopa
Aug 27 19:07:03 localhost bcm43xx: WARNING: Writing invalid LOpair (low: -48, high: 78, index: 120)
Aug 27 19:07:03 localhost [] [] [] [] [] [] [] []
Aug 27 19:07:03 localhost bcm43xx: set security called, .active_key = 0, .level = 1, .enabled = 1, .encrypt = 1, .auth_mode = 0
Aug 27 19:07:03 localhost bcm43xx: Radio turned off
Aug 27 19:07:03 localhost bcm43xx: Radio turned off
Aug 27 19:07:03 localhost bcm43xx: DMA-32 0x0200 (RX) max used slots: 1/64
Aug 27 19:07:03 localhost bcm43xx: DMA-32 0x02A0 (TX) max used slots: 0/512
Aug 27 19:07:03 localhost bcm43xx: DMA-32 0x0280 (TX) max used slots: 0/512
Aug 27 19:07:03 localhost bcm43xx: DMA-32 0x0260 (TX) max used slots: 0/512
Aug 27 19:07:03 localhost bcm43xx: DMA-32 0x0240 (TX) max used slots: 0/512
Aug 27 19:07:03 localhost bcm43xx: DMA-32 0x0220 (TX) max used slots: 2/512
Aug 27 19:07:03 localhost bcm43xx: DMA-32 0x0200 (TX) max used slots: 0/512
Aug 27 19:07:04 localhost sshd[13197]: error: Bind to port 22 on 192.168.13.14 failed: Cannot assign requested address.

а вот после ручной команды

/etc/init.d/net.eth0 start


Aug 27 19:10:03 localhost bcm43xx: Microcode rev 0x127, pl 0xe (2005-04-18 02:36:27)
Aug 27 19:10:03 localhost bcm43xx: Radio turned on
Aug 27 19:10:03 localhost bcm43xx: ASSERTION FAILED (radio_attenuation < 10) at: drivers/net/wireless/bcm43xx/bcm43xx_phy.c:1496:bcm43xx_find_lopa
Aug 27 19:10:03 localhost bcm43xx: WARNING: Writing invalid LOpair (low: 114, high: 101, index: 120)
Aug 27 19:10:03 localhost [] [] [] [] [] [] [] []
Aug 27 19:10:03 localhost bcm43xx: ASSERTION FAILED (radio_attenuation < 10) at: drivers/net/wireless/bcm43xx/bcm43xx_phy.c:1496:bcm43xx_find_lopa
Aug 27 19:10:03 localhost bcm43xx: WARNING: Writing invalid LOpair (low: 114, high: 101, index: 120)
Aug 27 19:10:03 localhost [] [] [] [] [] [] [] []
Aug 27 19:10:03 localhost bcm43xx: Chip initialized
Aug 27 19:10:03 localhost bcm43xx: 32-bit DMA initialized
Aug 27 19:10:03 localhost bcm43xx: Keys cleared
Aug 27 19:10:03 localhost bcm43xx: Selected 802.11 core (phytype 2)
Aug 27 19:10:03 localhost bcm43xx: ASSERTION FAILED (radio_attenuation < 10) at: drivers/net/wireless/bcm43xx/bcm43xx_phy.c:1496:bcm43xx_find_lopa
Aug 27 19:10:03 localhost bcm43xx: WARNING: Writing invalid LOpair (low: 114, high: 101, index: 120)
Aug 27 19:10:03 localhost [] [] [] [] [] [] [] []
Aug 27 19:10:03 localhost bcm43xx: set security called, .active_key = 0, .level = 1, .enabled = 1, .encrypt = 1, .auth_mode = 0
Aug 27 19:10:03 localhost SoftMAC: Open Authentication completed with 00:14:2b:02:b8:60
Aug 27 19:10:04 localhost rc-scripts: You are using a deprecated configuration syntax for eth0
Aug 27 19:10:04 localhost rc-scripts: You are advised to read /etc/conf.d/net.example and upgrade it accordingly
Aug 27 19:10:04 localhost dhcpcd[14022]: MAC address = 00:14:a5:6d:fd:26
Aug 27 19:10:05 localhost dhcpcd[14022]: verified 192.168.13.14 address is not in use
Aug 27 19:10:05 localhost dhcpcd[14022]: your IP address = 192.168.13.14

видимо что-то стартует после попытки поднятия сети, но что?

»

Настройки просмотра комментариев

Выберите нужный метод показа комментариев и нажмите "Сохранить установки".