VIA EPIA-PX и lm-sensors

в ядре включены все hardware monitoring и i2c драйвера.
вот что показывает sensors-detect: (сокращено)

Some south bridges, CPUs or memory controllers contain embedded sensors.
Do you want to scan for them? This is totally safe. (YES/no): y
VIA C7 thermal sensor...                                    Success!
    (driver `via-cputemp')

Some Super I/O chips contain embedded sensors. We have to write to
standard I/O ports to probe them. This is usually safe.
Do you want to scan for Super I/O sensors? (YES/no): y
Probing for Super-I/O at 0x2e/0x2f
Trying family `VIA/Winbond/Nuvoton/Fintek'...               Yes
Found unknown chip with ID 0xfc01
Probing for Super-I/O at 0x4e/0x4f

Lastly, we can probe the I2C/SMBus adapters for connected hardware
monitoring devices. This is the most risky part, and while it works
reasonably well on most systems, it has been reported to cause trouble
on some systems.
Do you want to probe the I2C/SMBus adapters now? (YES/no): y
Using driver `i2c-viapro' for device 0000:00:11.0: VIA Technologies CX700 South Bridge
Module i2c-dev loaded successfully.

Next adapter: via_i2c (i2c-0)
Do you want to scan it? (YES/no/selectively): y

Next adapter: SMBus Via Pro adapter at 0500 (i2c-1)
Do you want to scan it? (YES/no/selectively): y
Client found at address 0x50
Probing for `Analog Devices ADM1033'...                     No
Probing for `Analog Devices ADM1034'...                     No
Probing for `SPD EEPROM'...                                 No
Probing for `EDID EEPROM'...                                No

Now follows a summary of the probes I have just done.
Just press ENTER to continue:

Driver `via-cputemp':
  * Chip `VIA C7 thermal sensor' (confidence: 9)

то есть обнаружился только датчик температуры процессора. К кулеру идут 2 провода, так что FAN значений я и не ожидал, но вольтажи и температура чипсета быть должна.
На схеме показаны VIA SUPER IO LITE VT1212 и HW MONITOR ADM1032. По первому драйвера не нашел (vt1211 не грузится), по ADM1032 в drivers/hwmon/lm90.c есть This driver also supports the ADM1032. modprobe lm90 проходит, значит, насколько я понимаю, ADM1032 найден, однако как с него получить значения?

вот еще непонятно като такой unknown chip with ID 0xfc01 и как с ним бороться...

Заранее спасибо за помощь )